REMEHA Quinta 85 Technical Information download pdf (Page 30)

Remeha Quinta 85

7 INSTALLATION INSTRUCTIONS

7.1 General

The complete installation must comply with the current editions of relevant British

Standards and codes of practice, including the latest local and national regulations for

this type of equipment.

All gas appliances must, by law, be installed by a competent qualified engineer

registered with CORGI and holding the relevant qualifications and certificates (for

example ACOPS and IEE regs.)

Important:

The Remeha Quinta 85 is a CE certified appliance and must not therefore be modified

or installed in any way contrary to these “Installation and Maintenance Instructions”.

These manufacturer’s Instructions must NOT be taken as overriding statutory

obligations. Failure to install this appliance correctly could result in an unsafe condition

which can lead to prosecution. It is your own interest and that of safety to ensure that

the law is complied with.

7.2 Location

The remeha Quinta 85 is primarily

designed for wall mounting (on the

bracket supplied). The wall should be

flat, vertically plumb and capable of

supporting the full weight of the boiler full

of water. An optional floor frame can be

used for a free standing installation or

where the wall cannot carry the weight.

The following minimum clearances are

required:

- Front: 600 mm

- Sides: 25 mm

- Bottom: 250 mm

- Top: 400 mm.

Fig. 05 Minimum clearances around

the boiler

05.W4H.79.00026

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 67 68

No comments

REMEHA Quinta 85 Technical Information Page 30